Polyethylene Well Pipe - Submersible Well Water Pumps & ...

Author: wenzhang1

Jun. 10, 2024

Rubber & Plastics

Polyethylene Well Pipe - Submersible Well Water Pumps & ...

Choosing Well Pipe

When installing a submersible pump it is important to select pipe that has a pressure rating that matches or exceeds the working pressure that will exist in the well.

If you are looking for more details, kindly visit Water Well UPVC Filter Pipe.

Two factors are used to determine Working Pressure:
  1. Number of feet from the pressure tank to the pumping water level
    (One Foot of Water Depth = .433 PSI)
  2. The setting of the tank pressure switch(in PSIG)
The following formula will provide the Working Pressure:

(Depth X .433) + (switch setting) = Working Pressure



For example, if the pumping level is 330 ft. and the Pressure Switch is set at 50 PSIG the formula will be:

(330 X .433) + 50 = 192.9 PSI

A pipe with a rating of 200 PSI or greater is needed. Use of pipe with a lower pressure rating may result in pipe failure.

Please Note: If the pumping level used to calculate pipe requirements for a well is substantially above the bottom and the pumping level drops due to drought or other conditions, the pressure rating of the pipe could be exceeded.

Plumbing & Pipes for your Pond

Flexible PVC Pipe - advantages vs disadvantages

PVC pipe is also available in a flexible variety that is much easier to install than rigid PVC. Instead of needing to glue in fittings for every turn or bend like with rigid PVC, the flex pipe can just bend on its own. This is very convenient for hooking up to filters, skimmers or other equipment at odd angles. It&#;s usually available in 1-1/2&#;, 2&#;, 3&#; and 4&#;. The larger the diameter, the less flexible the pipe will become, so for very tight spaces and bends, 2&#; or less is the most flexible.


You might be wondering why someone would even consider using rigid PVC if flexible PVC is so much easier to use. Flexible PVC has some downsides that are more of an issue on large pond installs:

You might be wondering why someone would even consider using rigid PVC if flexible PVC is so much easier to use. Flexible PVC has some downsides that are more of an issue on large pond installs:

For more information, please visit HDPE Dredging Pipes for Philippines.


1) Extra friction.

With flexible PVC pipe, the walls are slightly ribbed to allow the pipe to bend. This means you&#;re going to end up with a little more friction in the pipe. Most people measure this to be around 5% to 10% less efficient than regular rigid PVC. More friction equals more resistance that the pump must overcome. For the main pipes and longer runs where you don&#;t really need the high flexibility, most contractors choose to use rigid. For our ecosystem pond, because the pipe runs aren&#;t that long, and we don&#;t have a lot of complicated filtration equipment like in a dedicated koi pond, we like flexible pipe. Although we will lose a little bit to friction using flexible pipe, for most ecosystem ponds it&#;s not really enough to worry about.


2) Flexible PVC isn&#;t as strong as rigid PVC.

If enough weight is put onto a flexible PVC pipe it can begin to &#;squish.&#; This is another reason many contractors still prefer to use rigid PVC&#;it can be buried with quite a bit of force on it and it&#;s not going to bend or break. In the past, flexible PVC pipe wasn&#;t good enough to run underground, which is why many people still don&#;t like it. However, the newer flexible PVC available can handle being buried with some weight on it, as long as the ground around the pipe is well compacted. It obviously still can&#;t handle as much weight as rigid PVC, but it&#;s enough for our ecosystem pond purposes.

3) Termites.

We have heard reports of termites eating through flexible PVC pipe in certain areas. If you believe you might have a termite problem where you live, you may want to consider rigid PVC instead, since the termites aren&#;t able to eat through the hard plastic as easily.


4) Flexible PVC needs PVC fittings (not ABS fittings).

This isn&#;t as much a disadvantage as just something to keep in mind. When choosing fittings to use with flexible PVC pipe, we find it&#;s better to use PVC pressure rated fittings rather than the ABS fittings mentioned earlier. The main reason is that schedule 40 PVC fittings are rated for pressure, and as a result have a larger gluing area. The ABS fittings have a smaller gluing area, which is fine for rigid pipe but is too small to get a good connection with flexible pipe.

The company is the world’s best DN630mm HDPE Water Supply Pipes supplier. We are your one-stop shop for all needs. Our staff are highly-specialized and will help you find the product you need.

76

0

Comments

Please Join Us to post.

0/2000

All Comments ( 0 )

Guest Posts

If you are interested in sending in a Guest Blogger Submission,welcome to write for us!

Your Name: (required)

Your Email: (required)

Subject:

Your Message: (required)